Malmet Bedpan / Urinal Bottle Washer Disinfector (ES-D)
Detergent Model with Hands Free Operation
Operation, Maintenance and Installation Manual
Issue 5 Page 34 June 23
Loading Bed Pans
Diagram B2
Side View Top View
Diagram B3 Diagram B4
5.16 Making equipment safe after incomplete operating cycle
If an incomplete cycle has occurred, it is assumed that the load being processed has not been subjected to a complete
cycle as per the set process parameters. For this reason, access to the load is restricted and will not be allowed until a full
cycle has been completed.
At the end of an incomplete cycle or on powering up the device after an incomplete cycle, a fault code will display relating
to the cause of the incomplete cycle (Please see section 5.3 Fault list for description of fault code). Depending on the
nature of the fault an error reset may need to be completed; this can be done by following the instructions below. If the
device does not allow an Error Reset to be completed, or the fault re-occurs after an Error Reset, it is recommended that
the device is isolated and service is arranged to correct the fault.
To Next Page
Loading...
