Operator Manual –PROCUT 3000 MP
11
8. OPERATING THE MACHINE
Attaching to the tractor
When connecting the tractor to the mower
Ensure the tractor cannot roll.
No one is standing between the tractor and
attachment
The mower is fitted with attaching points for category II.
Connect the top link onto the machine first.
Mount the machine on the lift arms secondly.
Attaching PTO to tractor
The tractor must be turned off when connecting the PTO
shaft to the tractor
When the PTO shaft has been connected, ensure the safety
clip has been firmly attached the tractor.
Attaching the hydraulics to the tractor
Only connect the hydraulics when the system is depressurised.
Pressurised hydraulics can cause serious injuries.
Check all joints, hoses and fittings regularly for leaks or visible
damage. The system is under high pressure and can cause
serious injury if failure occurs.
Avoid physical contact with hydraulic oil. Hydraulic oil
contains additives that can some serious consequence to your
health.
Reduce risk of contamination of dirt into hydraulic system.
When connecting hose to tractor, ensure fittings are clean of
dirt and oil. Contaminates can damage components in the
tractor and/or mower.
The mower requires two double acting hydraulic outputs.
Adjusting the ground pressure
Raising/lowering (Turning at headlands)
Work/ transport positions
To Next Page
Loading...