Malone PROCUT 3000 MP - Maintenance and Lubrication; Filling Oil Quantities and Lubrication Type; Gearbox Maintenance

Operator Manual –PROCUT 3000 MP
14
9. MAINTENANCE AND LUBRICATION
Check, and tighten (if required), all nuts, bolts and fixing’s after the first few hours of work
and at regular intervals thereafter. Grease every 20 hours of operation. Good maintenance of
a machine will ensure a safe working environment and long service life of the machine.
Filling oil quantities and lubrication type
Gearbox
You will need a 13mm spanner to access the drain and oil level plug, and a 19mm spanner to
access the fill plug.
 Place the mower and cutter-bar on level ground.
 Remove the fill and drain plug.
 Drain the used oil into a suitable container. Wait until all the oil has been fully
drained off.
 Refit the drain plug and remove the oil level plug on the gearbox.
 Insert the correct amount of oil into the gearbox through the fill plugs slowly until oil
starts to seep through the oil level plug.
 Replace the oil level plug and fill plug and ensure all plugs have been correctly
tightened.
Quantity (Litre)
Type
Primary Gearbox
1.5
SAE 90
Secondary Gearbox
1.5
SAE 90
Primary Gearbox
Secondary Gearbox
Oil
level
Drain
Fill