Malone PROCUT 3000 MP - Storage Procedures; Disc and Blade Maintenance

Operator Manual –PROCUT 3000 MP
16
Storage
The machine should be stored on a firm level site and cannot tip over, in a safe, clean
and dry location where itis protected from the elements. If the machine is not properly
secured when parked it can result in serious injury and death.
Parking Vertical
 Lift the cutter frame to its vertical position until the frame rests in its v-block and the
mechanical lock has been engaged.
 Fold out the three stabilisers legs.
 Lower the mower till all the three legs rests on the ground.
 Ensure the hydraulics has been depressurised.
 Turn off the engine of the tractor before disconnecting the PTO shaft from the tractor
and hydraulics.
 Disconnect the top link and lower link arms from the mower frame.
Parking Horizontal
 Lower the stabiliser leg and ensure the locking pin has been secured on it.
 Lower the mower until the stabiliser leg and cutter bar rests on the ground.
 Ensure the hydraulics has been depressurised.
 Turn off the engine of the tractor before disconnecting the PTO shaft from the tractor
and hydraulics.
 Disconnect the top link and lower link arms from the mower frame.
Disc and blade maintenance
For cutting and a longer service life carefully check discs, blades and bolts daily. Replace
worn or damaged blades and hardware immediately using only Malone recommended parts.
Replace blades, bolts and nuts in pairs to maintain balance. Ensure the cutting edge of blades
face the disc rotation direction.