EasyManua.ls Logo

MALTEC MasterCut5700W - Before Starting Engine

MALTEC MasterCut5700W
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WORKING GEAR AND CLOTHING
a. When using the product, you should wear proper clothing and protective equipment as
follows.
(1) Helmet
(2) Protection goggles or face Protector
(3) Thick work gloves
(4) Non-slip-sole work boots
(5) Ear protectors
b. And you should carry with you.
1. Attached tools and files.
2. Properly reserved fuel and chain oil.
3. Things to notify your working area (Rope, warning signs)
4. Whistle (for collaboration or emergency)
5. Hatchet or saw (for removal of obstacles)
c. Never use the product when wearing pants with loose cuffs, when wearing sandals, or
when barefoot
WARNING CONSIDERING HANDLING OF FUEL
a. The engine of this product is designed to run on a mixed fuel which contains highly
flammable gasoline. Never store cans of fuel or refill the fuel tank in any place where there
is a boiler stove, wood fire, electrical sparks, welding sparks, or any other source of heat or
fire which might ignite the fuel.
b. Smoking while operating the product or refilling its fuel tank is extremely dangerous.
Always be sure to keep lit cigarettes away from the product at all times.
c. When refilling the tank always turn off the engine first and take a careful look around to
make sure that there are no sparks or open flames anywhere nearby before refueling.
d. lf any fuel spillage occurs during refueling, use a dry rag to wipe up spills before turning
the engine back on again.
e. After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the
product to a spot 3m or more away from where it was refueled before turning on the
engine.
BEFORE STARTING ENGINE