(3) Make certain that the area in which you are cutting is free from obstructions Do not let
the nose of the guide bar contact a log, branch, or any other obstruction which could be hit
while you are operating the saw.
(4) Cut at high engine speed.
(5) Do not overreach or cut above shoulder height.
(6) Follow manufactures sharpening and maintenance instructions for saw chain.
(7)Only use replacement bars and chains specified by the manufacturer or the equivalent.
MAINTENANCE
In order to maintain your product in proper working order, perform the maintenance
and checking operations described in the manual at regular intervals.
Always be sure to turn off the engine before performing any maintenance or checking
procedures.
The metallic parts reach high temperatures immediately after stopping the engine.
Leave all maintenance other than the items listed in the Owner*s Manual to your
competent servicing dealer.
TRANSPORTATION
Always carry the unit with the engine stopped, the guide bar covered with the protector
to the rare, and muffler away from your body.
INSTALLING GUIDE BAR AND SAW CHAIN
A standard saw unit package contains the items as the items as illustrated.(F1)
(1) Power unit
(2) Bar protector
(3) Guide bar
(4) Chainsaw
(5) Plug wrench
(6) Screwdriver for carburetor adjustment
(7) Spike and mounting screws
Open the box and install the guide bar and the saw chain on the power unit as follows:
The saw chain has very sharp edges. Use thick protective gloves for safety.
5. Pull the guard towards the front handle to check that the chain brake is not on.
6. Loosen the nuts and remove the chain cover.
7. Install the attached spike to the power unit.
To Next Page
Loading...