SAWING
Before proceeding to your job, read " For Safe Operation" section. It is recommended
to first practice sawing easy logs. This also helps you get accustomed to your unit.
Always follow the safety regulations. The chain saw must only be used for cutting
wood. lt is forbidden to cut other types of material. Vibrations and kickback vary with
different materials and the requirements of the safety regulations would not be respected.
Do not use the chain saw as a lever for lifting, moving or splitting objects Do not lock it
over fixed stands. It is forbidden to hitch tools or applications to the p.t.o. that are not
specified by the manufacturer.
It is not necessary to force the saw into the cut. Apply only light pressure while running
the engine at full throttle.
When the saw chain is caught in the cut, do not attempt to pull it out by force, but use
a wedge or a lever to open the way.
GUARD AGAINST KICKBACK (F19)
This saw is equipped with a chain brake that will stop the chain in the event of
kickback if operating properly. You must check the chain brake operation before each
usage by running the saw at full the throttle for l-2 seconds and pushing the front hand
guard forward. The chain should stop immediately with the engine at full speed. If the
chain is slow to stop or does not stop, replace the brake band and clutch drum before use.
It is extremely important that the chain brake be checked for proper operation before
each use and that the chain be sharp in order to maintain the kickback safety level of this
saw. Removal of the safety devices. Inadequate maintenance, or incorrect replacement of
the bar or chain may increase the risk or serious personal injury due to kickback.
FELLING A TREE(F20)
1. Decide the felling direction considering the wind, lean of the tree, location of heavy
branches, ease of job after felling and other factors
To Next Page
Loading...