Be careful not to damage the PC paper on the build plate.
Take care to avoid touching hot parts, including heat blocks, extruder nozzle,
extruded lament, and the heated build plate.
Do not wear gloves when operating or repairing to avoid entanglement.
Keep the printer and all accessories out of reach of children.
Do not remove or disconnect the USB cable when printing from a computer.
Do not pull or twist the black cable at any time.
Do not force or tear anything during unpacking and setup. This may cause
damage to the printer and/or its accessories.
Do not reach inside the printer during operation.
Always allow the printer and extruded lament to cool before reaching inside.
Ensure that the printer is turned o and unplugged from its power source
before making repairs or performing service.
Do not install this device on an unstable surface where it could fall and cause
either personal injury or damage to the device and/or other equipment.
Do not subject the product to extreme force, shock, or uctuations in
temperature or humidity.
This device is intended for indoor use only.
Do not expose this device to water or moisture of any kind. Do not place
drinks or other containers with moisture on or near the device. If moisture
does get in or on the device, immediately unplug it from the power outlet
and allow it to fully dry before reapplying power.
Do not touch the device, the power cord, or any other connected cables
with wet hands.
Use only in a well-ventilated area. Do not use in close, conned spaces.
SAFETY WARNINGS AND GUIDELINES
03
To Next Page
Loading...
