Screw from the Left Y Axis Carriage Bar, then replace the plastic
brackets and tighten the screws to secure them in place.
Using the included 3mm hex wrench, loosen the screw in the top of
the motor coupling, so that the Z Axis Lead Screw can be inserted.
Insert the Z Axis Lead Screw through the hole in the top of the frame,
then thread the it through the hole on the extruder housing until the
unthreaded portion of the screw is fully inserted into the motor coupling.
When it is properly inserted, the top will be ush with the frame. Tighten
the screw loosened in the previous step to secure the Z Axis Lead Screw
to the motor.
Using the 2.5mm hex wrench and 2x M4x6 screws, x the LCD Display
Module to the the printer frame. Insert the plug into the back of the module.
Align the t-nuts in the frame with the holes on the lament holder, then
using the 2.5mm hex wrench and 2x M4x6 screws, secure the lament
holder to the frame.
Mount the extruder hotend to the bracket on the X Axis Gantry by aligning
the positioning rods and magnets. Ensure that the cables are on top.
Plug the three cable connectors into the appropriate connections on the
front left side of the Left Y Axis Carriage, beneath the Z Axis Lead Screw
storage location referenced in step 3 above.
SETUP
Perform the following steps to prepare the printer for use.
1. Put the printer on a at, stable surface with plenty of ventilation and a
nearby AC power outlet.
2. Ensure that the Power Switch is in the OFF position. Plug the included
AC Power Cord into the AC Power Connector jack on the right side of the
08
3.
4.
5.
6.
7.
8.
Warning! Take care not to remove or damage the printing surface on the build
platform. This paper is essential to ensure the 3D model properly adheres to
the build platform during printing.
To Next Page
Loading...
