1. Remove the battery cover.
Remove the battery chamber cover on the bottom of the
camera with a coin or screwdriver.
2. Insert the battery.
The + terminal is indicated on the inside of the battery
chamber cover. Insert the battery as shown in the
Illustration, being sure to properly place the battery with
the “+” side up, facing the cover.
* Batteries
The Mamiya 7II uses one of 4SR44 silver oxide
battery, 4LR44 alkaline battery or 2CR1/3 lithium
battery.
CAUTION : Insert the direction of battery polarities
("+" and "-") correctly.
Power ON
To turn the Power ON, align dot “A” on the power switch
lever with the “B” on the camera body.
Power OFF
To turn the Power OFF, align dot “A”
on the power
switch lever with the dot “C” on the camera body.
Shutter release button
The shutter release button is designed so that pressure
can be applied in two stages. When it is lightly touched,
correct metering data is displayed on the bottom of the
view finder. When it is depressed all the way, the shutter
is released and an exposure is made.
The LED's are located at the bottom of the finder in order
not to interfere with the field of view of the wide angle
lens.
To Next Page
Loading...
Need help?
General
