Mamiya ZE-2 - Check by a Tester and Trouble Shooting; Important

8-4 Check by a Tester an d trouble shooting
A. Important
l. When checking the electronic circuits and parts by using a ¡ester,
we recommend you to check them with the tester range OC\" but not range
OHMS.
2. When checking sorne of them wi th the OH~1S range, you should . choose the
range XlOO or XlOOO, but not XlO,OOO and do not forget to remove the
battery cartridge from the camera body.
3. Do not apply even if three volt or less and more directly to the IC
and LEO circuits when checking.
4. Do not touch the VRl, VR2, VR3, VR4 and VRS variable resistors with
your bare fingers .
S. Pay your
attention when handing with the flexible printed circuit
board because sorne parts on it are liable to hurt.
6. Always special attention should be payed to making fine soldering
joint.
- 26 -