3-41
G2/1
G2 WHEEL
CHANGE
Or this operation, we recommend that you use the MANITOU hydraulic jack, reference 505507,
and the MANITOU safety stand, reference 554772.
- Stop the lifting platform, if possible, on a firm, horizontal surface.
- Proceed to stop the lifting platform (see: 1 – SAFETY INSTRUCTIONS AND ADVICE: INSTRUCTIONS
FOR DRIVING WHEN UNLADEN AND LADEN).
- Wedge the lifting platform in both directions on the axle opposite the wheel to be changed.
- Unscrew the wheel nuts on the wheel to be changed until they can be removed without much
effort.
- Place the jack under the axle carrier, as close as possible to the wheel and adjust the jack (Fig.
G2/1).
- Lift the wheel until it separates slightly from the ground and set the safety stand under the axle
(Fig. G2/2).
The weight of one wheel is 134 kg.
- Unscrew the wheel nuts completely and remove them.
- Release the wheel by moving it to and fro and roll it to one side.
- Slip the new wheel onto the hub.
- Screw on the wheel nuts by hand; grease them, if necessary.
- Remove the safety stand and lower the lifting platform by means of the jack.
- Tighten the wheel nuts with a torque wrench (see: 3 - MAINTENANCE: B - EVERY 250 HOURS OF
OPERATION for the tightening torque).
G2/2
647400 EN (01/02/2015)
To Next Page
Loading...
