Ân
500H - PERIODIC MAINTENANCE - EVERY 500 HOURS OF SERVICE
REPLACE Engine oil
REPLACE Engine oil filter
IMPORTANT
Dispose of the drain oil in an ecological manner.
- Place the lift truck on level ground, let the engine run at idle for a few minutes,
then stop the engine.
- Open the engine cover ( 2 - DESCRIPTION: CONTROL AND COMMAND
INSTRUMENTS).
- Remove the cover plate 1.
- Clean the areas around the plugs and oil filter.
DRAINING THE OIL
- Place a container under drain port 2 and unscrew the plug.
- Remove the filler plug 3 to ensure that the oil is drained properly.
REPLACEMENT OF THE FILTER
- Unscrew and discard the engine oil filter 4, together with its seal.
- Clean the filter holder with a clean, lint-free cloth.
- Lightly lubricate the seal before refitting the new oil filter (
FILTERS, CARTRIDGES
AND BELTS) on its support (tightening torque 15-17 N.m).
FILLING WITH OIL
- Refit and tighten the drain plug 2 (tightening torque 30 to 40 N.m).
- Fill up with oil ( LUBRICANTS AND FUEL) through filler port 5.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks from the drain plug and the oil filter.
- Stop the engine; wait a few minutes
- Check the correct level between the two notches on dipstick 6.
- Top up the level if necessary.
GREASE Mast lifting chains
- Wipe the mast lifting chains with a clean, lint-free cloth
- Vigorously brush the chains to get rid of any foreign matter, with a hard nylon
brush and clean diesel fuel.
- Rinse the chains by means of a paint brush impregnated with clean diesel fuel and
dry them with a compressed air jet.
- Carefully check each chain for any signs of wear.
IMPORTANT
In case of technical faults, consult your dealer.
- Grease the chains sparingly ( LUBRICANTS AND FUEL).
3 - 20
2
6
1
3
5
4
647635 (12/12/2017)
To Next Page
Loading...
