Manitou MC 50 Turbo POWERSHIFT Serie 3-E3 - Page 145

3-37
D6 - GEAR BOX OIL FILTER
CHANGE
MC 40 Turbo POWERSHIFT Série 3-E3 MC 60 Turbo POWERSHIFT Série 3-E3
MC 50 Turbo POWERSHIFT Série 3-E3 MC 70 Turbo POWERSHIFT Série 3-E3
- Remove access panel 1 (fig. D6/1).
- Unscrew and discard gear box oil filter 2 (fig. D6/2).
- Carefully clean the filter head with a clean, lint-free cloth.
- Lightly grease the new oil filter seal and fit it on the filter (see: 3 - MAINTENANCE: FILTERS
CARTRIDGES AND BELTS).
- Refit the filter, making sure that the seal is correctly positioned and tightened.
Tighten the gear box oil filter by hand pressure only and lock the filter in place by a quarter turn.
- Refit access panel 1 (fig. D6/1).
D7 - MAST LIFTING CHAINS
CLEAN - CHECK - GREASE
- Wipe the mast lifting chains 1 (fig. D7) with a clean, lint-free cloth, then examine them closely
so as to detect any signs of wear.
- Vigorously brush the chains to get rid of any foreign matter, with a hard nylon brush and clean
diesel fuel.
- Rinse the chains by means of a paint brush impregnated with clean diesel fuel and dry them
with a compressed air jet.
- Moderately lubricate the chains (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL).
In case of technical faults, consult your dealer.
D8 - HYDRAULIC RETURN OIL FILTER CARTRIDGE
CHANGE
Stop the I.C. engine and remove the pressure from the circuits by acting on the hydraulic controls.
Thoroughly clean the outside of the filter and its surroundings before any intervention in order to prevent any
risk of polluting the hydraulic circuit.
- Open the I.C. engine bonnet.
- Unscrew the locking screws of the cover 1 (fig. D8).
- Remove the hydraulic return oil filter cartridge 2 (fig. D8), and fit new replacement cartridge
(see: 3 - MAINTENANCE: FILTERS CARTRIDGES AND BELTS).
- Make sure that the cartridge is correctly positioned and refit cover 1 (fig. D8).
D7
1
D8
2
D6/2
2
D6/1
1
1
647003 EN (03/01/2012)