Manitou MC 50 Turbo POWERSHIFT Serie 3-E3 - Page 146

3-38
D9 - PARKING BRAKE LEVER MECHANISM
GREASE
- Clean and grease articulation axles 1 (fig. D9) with grease (see: 3 - MAINTENANCE: LUBRICANTS
AND FUEL).
D10 - CAB VENTILATION FILTER
CLEAN
Optional for MC 30 Turbo Série 3-E3
- Remove protective casing 1 (fig. D10/1).
- Lift out cabin ventilation filter 2 (fig. D10/2).
- Clean the filter using a compressed air jet.
- Check its condition and change if necessary (see: 3 - MAINTENANCE: FILTERS CARTRIDGES AND
BELTS).
- Refit the filter and protective casing.
D11- FRONT AXLE DIFFERENTIAL OIL (without cooler of oil)
DRAIN
Except for : MC 40 Turbo POWERSHIFT Série 3-E3
MC 50 Turbo POWERSHIFT Série 3-E3
Place the lift truck on level ground with the I.C. engine stopped and the differential oil still warm.
Dispose of the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. D11) and unscrew the plugs.
- Remove level plug 2 (fig. D11) and filler plug 3 (fig. D11) in order to ensure proper emptying.
- Refit and tighten drain plugs 1 (fig. D11) (tightening torque 34 to 49 N.m).
-
Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through filler port 3 (fig. D11).
- The level is correct when the oil level is flush with the edge of port 2 (fig. D11).
- Check for any possible leaks at the drain plugs.
- Refit and tighten level cap 2 (fig. D11) (tightening torque 34 to 49 Nm) and filler port 3 (fig. D11) (tightening torque 34 to 49 N.m).
D9
1
1
1
D10/2
D10/1
1
2
D11
2
1
1
1
3
647003 EN (03/01/2012)