1 - 161 - 16
22
11
F3F3
3
3
22
11
F4F4
1
1
33
22
F5F5
release the load. Retract (2) and lower the boom (3) to bring the load into the transportrelease the load. Retract (2) and lower the boom (3) to bring the load into the transport
position (fig. F5).position (fig. F5).
F6F6
1
1
22
33
F7F7
LAYING A HIGH LOAD ON TIRESLAYING A HIGH LOAD ON TIRES
- Approach with the load in the transport position in front of the pile (fig. F6).- Approach with the load in the transport position in front of the pile (fig. F6).
- Put the handbrake on and set the reversing lever to neutral.- Put the handbrake on and set the reversing lever to neutral.
- Lift and extend the boom (1) (- Lift and extend the boom (1) (2) until the load is above the pile,2) until the load is above the pile, while keeping an eye onwhile keeping an eye on
the load. If nethe load. If necessary,cessary, move the lift truck (move the lift truck (3) forward (3) forward (fig. F7),fig. F7), driving very slowly and care-driving very slowly and care-
fully.fully.
- Place the load in a horizontal position and lay it down on the pile by lowering and retrac-- Place the load in a horizontal position and lay it down on the pile by lowering and retrac-
ting the boom (1) (2) in order to position the load correctly (fig. F8).ting the boom (1) (2) in order to position the load correctly (fig. F8).
- I- If possible,f possible, release the fork by alternately retracting and release the fork by alternately retracting and raising the boom (1) (fig. F9).raising the boom (1) (fig. F9).
Then set the forks into transport position.Then set the forks into transport position.
- I- If this is not possible,f this is not possible, reverse the lift truck (1) very slowly and carefully to release thereverse the lift truck (1) very slowly and carefully to release the
forks (fig. F10). Then set them into transport position.forks (fig. F10). Then set them into transport position.
CONTENTSCONTENTS
To Next Page
Loading...
