EasyManua.ls Logo

Manitou MLA 628 -120 LSU 3-E2 Series - If the Lift Truck Is Not to be Used for a Long Time

Manitou MLA 628 -120 LSU 3-E2 Series
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 - 211 - 21
IF THE LIFT TRUCK IS NOT TO BE USED FOR A LONG TIMEIF THE LIFT TRUCK IS NOT TO BE USED FOR A LONG TIME
IINTRODUCTIONNTRODUCTION
The following recommendations are intended to prevent the lift truck from being damaged when The following recommendations are intended to prevent the lift truck from being damaged when it is withdrawn from service for anit is withdrawn from service for an
extended period.extended period.
For these operatFor these operations,ions, we recommend the use we recommend the use of protective products.of protective products.
Instructions for using the product are given on the packaging.Instructions for using the product are given on the packaging.
Procedures to follow if the lift truck is not to be used for a long time and for starting it up again afterwards must be performed by your dea-Procedures to follow if the lift truck is not to be used for a long time and for starting it up again afterwards must be performed by your dea-
lership.lership.
PPRREPEPARARININGG THTHEE LLIFIFTT TRTRUUCCKK
- Clean the - Clean the lift truck thoroughly.lift truck thoroughly.
- Check and repai- Check and repair any leakage of fuer any leakage of fuel,l, oil,oil, watewater or airr or air..
- Replace or repair any worn or damaged parts.- Replace or repair any worn or damaged parts.
- Wash the painted surfaces of the lift truck in clear and cold water and wipe them.- Wash the painted surfaces of the lift truck in clear and cold water and wipe them.
- Touch up the paintwork if - Touch up the paintwork if necessary.necessary.
- Shut down the lift - Shut down the lift truck (seetruck (see : OPERA: OPERATING INSTRUCTIONS UNLADEN AND LADEN).TING INSTRUCTIONS UNLADEN AND LADEN).
- Make sure the boom cylinder rods are all in retracted position.- Make sure the boom cylinder rods are all in retracted position.
- Release the pressure in the hydraulic circuits.- Release the pressure in the hydraulic circuits.
It is recommended that your dealer perform the following procedures for lift truck storage and returning it to service.It is recommended that your dealer perform the following procedures for lift truck storage and returning it to service.
IMPORTANTIMPORTANT
CONTENTSCONTENTS
https://www.forkliftpdfmanuals.com/

Related product manuals