Manitou MT 1840 R PRIVILEGE User Manual

3-13
A5 - CYCLONIC PRE-FILTER (OPTION)
CLEAN
The cleaning interval is given as a guide, however the prefilter must be emptied as soon as
impurities reach the MAXI level on the tank.
- Loosen nut 1 (fig. A5), remove cover 2 (fig. A5) and empty the tank.
- Clean the prefilter unit with a clean dry cloth and reassemble the unit.
When cleaning, take care not to let impurities into the dry air filter.
A6 - GEAR BOX OIL LEVEL
CHECK
Park the lift truck on level ground with the jib raised, the I.C. engine cold and stopped. Carry
out the control within 5 minutes of the I.C. engine being stopped.
- Raise the jib and remove protective guard back 1 (fig. A6/1).
- Remove dipstick 2 (fig. A6/2) by unscrewing it.
- Wipe the dipstick and check the correct level against the MAX mark.
- If necessary, add oil (see: 3 - MAINTENANCE: E4 - GEAR BOX OIL) through filler port 3
(fig. A6/2).
- Screw the dipstick back in whilst pressing it down so as to ensure its hold and its
airtightness.
- Check visually that there is no leakage or seepage of oil in the transmission.
A7 - TYRES PRESSURE AND WHEEL NUTS TORQUE
CHECK
- Check the condition of the tyres, to detect cuts, protuberances, wear, etc.
- Check the torque load of the wheel nuts. Non compliance with this instruction can cause damage and rupture to the wheel bolts
and distortion to the wheels.
Wheel nuts tightening torque
• Front tyres: 630 N.m ± 15%
• Rear tyres: 630 N.m ± 15%
- Check and adjust the tyre pressures if necessary (see: 2 - DESCRIPTION: FRONT AND REAR TYRES).
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation. Respect the
recommended tyre pressures given.
NOTE: There is an OPTIONAL wheel toolkit.
A8 - JIB PADS
CLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service,
then once at 250 hours.
- Extend the jib completely.
- With a brush, apply a coat of grease (see: 3 - MAINTENANCE:
LUBRICANTS AND FUEL) on the 4 sides of the telescope(s) (fig. A8).
- Telescope the jib several times in order to spread the coat of grease
evenly.
- Remove the surplus of grease.
If the lift truck is used in an abrasive environment (dust, sand, coal…) Use
lubricating varnish (MANITOU reference: 483536). In this respect, consult your dealer.
A6/1
1
A6/2
2
3
A5
1
2
A8

Manitou MT 1840 R PRIVILEGE Specifications

General

Brand	Manitou
Model	MT 1840 R PRIVILEGE
Category	Forklifts
Language	English