18
R7 EXPERT / PRO SERVICE GUIDE
CASTING INSTALL
8
7
Using the Manitou 8mm Thin Wall
Socket and torque wrench, turn
the compression rod counter-
clockwise. Torque to
30-40 in lbs [3,4-4,5 N m].
Do not overtighten, as doing so can
damage the end of the rods.
Install rebound knob. Holding
the knob steady, use a 2mm hex
wrench to assemble the rebound
knob screw (rotating clockwise) and
torque to 0.5-0.7 in lb [4-6 N m].
To Next Page
Loading...
