Manitou R7 PRO - Casting Installation

16
R7 EXPERT / PRO SERVICE GUIDE
CASTING INSTALL
1
2
3
Apply a thin layer of either
Slickoleum grease or semi-bath
oil to the inside surface of the fork
seal.
Tightly assemble shock pump tting
to comp rod end tting. Inate the
air spring to 50 PSI. The air spring
should not move during ination.
With the shock pump still attached,
lightly pull the comp rod to full
extension so that some compression
of the internal top-out bumper can be
felt. Remove the shock pump. This
process will ease casting installation.
Lightly pull the rebound damper
rod to full extension.