Grove Published 3-23-2020, Control # 654-04 4-15
GRT655/655L OPERATOR MANUAL OPERATING PROCEDURES
• Secure steering to prevent turning while towing.
• Conduct all travel with assistance of a ground person to
warn operator of any changing conditions in terrain
being traversed.
Traveling on Slopes
Crane operators must exercise caution whenever operating
the crane on uneven surfaces. Travel on slopes is permitted
if the following conditions are met.
General Conditions
• Travel must be on an improved surface or hard-packed
dry earth. Crane operators are required to inspect the
surface for good tire adhesion.
• All boom sections must be fully retracted.
• Boom extension must be in stowed position or removed
from the crane (if traveling with an erected boom
extension, follow the requirements under the section
Traveling with Boom Extension Erected, page 4-18
• Boom must be positioned over the front of the crane.
Boom angle must be as follows:
- For fore/aft travel on grades less than 15%, the
maximum allowable boom angle is 20°.
- For fore/aft travel on grades greater than 15%, the
boom angle must be limited to horizontal (0°).
- For side slope travel on grades less than 10%, the
maximum allowable boom angle is 20°.
- For side slope travel on grades greater than 10%,
the boom angle must be limited to horizontal (0°).
• Swing brake must be applied and turntable lock pin
engaged.
• Either the hook block may be reeved over the main
boom nose, or the overhaul ball may be reeved over the
main boom nose or auxiliary boom nose; the other must
be removed. If hook block or overhaul ball remains
reeved on the boom, it must be secured at the tie down
on the carrier to prevent swinging.
• Tires must be inflated to the recommended pressure for
pick and carry operations.
• Hydraulic tank must be filled to specified level. Fuel tank
must be over half full.
• Engine and transmission fluids must be filled to the
specified levels.
• Axle differentials and planetary hub fluids must be filled
to the specified levels.
• No loads may be supported by the boom (i.e., no pick
and carry loads) while traversing a slope.
• All cribbing or other non-standard accessories must be
removed from the crane.
• Avoid holes, rocks, extremely soft surfaces, and any
other obstacles that might subject crane to undue
stresses and possible overturn.
• Operator is to check for changing road conditions and
utilize a ground person if deemed necessary.
DANGER
Run-away Crane Hazard!
Disabling parking brake may result in crane rolling away
freely without the ability of the operator to stop the crane.
Make sure that the crane is attached to an adequately
sized tow vehicle before disabling the parking brake.
Death or serious injury and damage to machinery could
result from moving machinery.
To Next Page
Loading...
Need help?
General
