Maintenance Section 4
4-2
Part Number 020002392 04/09
MONTHLY CLEANING
Clean and sanitize the ice bin:
1. Unplug unit and remove all ice and components
from the ice bin.
2. Mix a solution of mild detergent to clean the
dispenser bin and components.
3. Wash the ice bin using a sponge and the mild
detergent solution.
4. Using the mild detergent solution and a soft bristle
brush or clean cloth, clean the following bin and
selectable ice components;
Bin components:
A. Merchandiser
B. Ice Chute
C. Rear bushing & pin (Front Serviceable Units)
D. Agitator
E. Agitator Pin (Non-Front Serviceable Units)
F. Paddle wheel
G. Entire bin
H. Motor shaft
• Strip lids (where applicable)
5. Rinse all the parts in clean, running water.
6. Prepare 2 gallons of sanitizing solution by mixing
1/2 ounce of household bleach (that contains 5.25%
sodium hypochlorite) with 2 gallons of 120°F water.
The mixture should not exceed 100 PPM of chlorine.
Or mix a solution of any approved sanitizer, following
the directions for mixing and applying the sanitizer.
7. Sanitize the ice bin and cold plate with the sanitizing
solution for at least 10 seconds.
8. Allow to air dry. Do not rinse.
9. Re-assemble all bin components once dry and hand
tighten all knurled fasteners.
10. Pour in fresh, sanitary ice and replace the lid on the
top of the dispenser.
11. Plug in the unit’s electrical cord.
12. Check for proper ice dispensing.
Unplug unit before servicing or cleaning ice bin.
Ice bin contains parts that can move at any time and
will cause injury if hands are in the way.
When using cleaning fluids or chemicals, rubber
gloves and eye protection must be worn.
To Next Page
Loading...
Need help?
General