56 Part Number STH039 8/13
SAFETY LIMIT FEATURE
In addition to the standard safety controls, your
Manitowoc ice machine features built-in safety limits
that will stop the ice machine if conditions arise which
could cause a major component failure.
Before calling for service, re-start the ice machine
using the following procedure:
1. Move the ON/OFF/WASH switch to OFF and then
back to ON.
2. If the safety limit feature has stopped the ice
machine, it will restart after a short delay. Proceed
to step 4.
3. If the ice machine does not restart, see “Ice
machine does not operate”.
4. Allow the ice machine to run to determine if the
condition is reoccurring.
A. If the ice machine stops again, the condition
has reoccurred. Call for service.
B. If the ice machine continues to run, the
condition has corrected itself. Allow the ice
machine to continue running.
To Next Page
Loading...
Need help?
General