EasyManua.ls Logo

Manitowoc UG080A - Page 53

Manitowoc UG080A
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
Check Procedure
1. Make sure the thermistor sensors installation
correctly
2. Disconnect thermistor from control board and
measure resistance.
3. Measure temperature at the thermistor.
4. Compare measured resistance/
temperature.Creadings to resistance/temperature
relationship
Within 10% of the published resistance value-
Thermistor is good
Not within 10% of the published resistancevalue -
Thermistor is defective.

Table of Contents

Other manuals for Manitowoc UG080A

Related product manuals