Manley VOXBOX - TECHNICAL SPECIFICATIONS; PREAMPLIFIER AND EQ SPECIFICATIONS; UNIT OVERALL SPECIFICATIONS

SPECIFICATIONS
MANLEY VOXBOX
PREAMPLIFIER EQ SECTION BOTH
Maximum Output : 1.5% THD
Unbalanced: 20-20k +31 dBv
Balanced: 1 kHz +31 dBv`
Headroom (referenced to +4 dBv) 27 dB
THD & Noise (1kHz @ +20 dBm) .3%
Frequency Response: +/- 1 dB 20 Hz to 60 kHz
Noise Floor (settings to minimum) -86 dB (A Weight)
Signal to Noise 113 dB typical
Maximum input level MIC +20
Input Impedance MIC 2000 Ohms
LINE 3000 Ohms
INST 100,000 Ohms
Maximum Gain MIC 60 dB
LINE 20 dB
INST 20 dB
Maximum Compression/Limiting 16 dB
Maximum Limiting with +4 dBm sine 8 dB
Attack Times 4 mS - 70mS
Release Times .3, .5, 1, 2, 5 Sec
Compress / Limit Ratios 3:1
+31 dBv
+31 dBv
27 dB
.3%
10 Hz to 100 kHz
-89 dB (A Weight)
116 dB typical
LINE +40
3000 Ohms
INSERT 0dB
(internal trim)
32 dB
5 dB
2 mS
.5 Sec
10:1
+31 dBv
+31 dBv
27 dB
.35%
20 Hz to 60 kHz
-84 dB
110 dB typical
Power Consumption 24 watts 200 mA @ 115VAC
Fuse Mains 120VAC= 1 Amp Slo-Blo
Mains 240VAC= 1/2 Amp Slo-Blo
Size (3U) 19” x 5.25” x 10”
Actual Weight 14 Lbs
Shipping Weight 21 Lbs
(gain pot & compressor before tubes and these allow much range, however transformers may saturate)
23