EasyManuals Logo

Mantis 7222 User Manual

Mantis 7222
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
TROUBLE SHOOTING
Problem Cause Remedy-
Tines don't turn when throttle + Engine is not seated properly on the gear + Re+instaI1 engine following the instructions
is depressed on page I2 (How to reseat the _Tange).
2. Engine fails to start O11switch is in +o" position, Move switch to _+12+
3_ Engine hard to start.
4. Engine continuously floods.
* No fuel in tank.
+ Fuel strainer clogged.
* Fuel line clogged.
, Spark plug shorted or fouled+
* Spark plug is broken (cracked
porcelain or electrodes broken)
, ignition lead wire shorted, broken or
disconnected from spark plug.
* Ignition inoperative
* '&'ater in gasoline or stale fiael mixture.
+ lbo much oil i_ iuel mixture+
* Engine under or over choked
* Carbm,:tor out of adjustmenL
- Gasket leaks (carburetor or cylinder
base gaske0+
Weak spark at spark plug.
+ Fuel tank vent line is not in an
upright position.
o
Q
o
o
Fill Tank.
Replace Strainer.
Clean fuel line
Install new spark plug.
Replace spark plug.
Replace lead wire or attach to spark plug
Contact your local authorized dealer+
Drain entire system and refill with
fresh fuel.
Drair_ and refill with correct mixture.
If flooded by over choking, proceed
according to instructions iu operation+
section, If under choked, move choke
lever to dosed position m_d crank two or
three times.
See "Carbtxretor Adjustment'
Replace gaskets.
Contact your local authorized dealer+
Return the t:uel tank vent line to the
upright: position and place it under the
cyiinder cover in the small pocket" in
the cylinder cover
5+ There is black smoke coming from * The muffler screen is clogged * Clean carbon frorn mufIler screen (page 12)
exhaust
6. Engine misses.
+ Remove and clean.
* See '_Carburetor Adjustment2
* Clean or replace spark plug - set gap to
024-.028 in. (06-0.7 mm)
- Comact your local authorized dealer.
* Dirt in tuel line or carburetor.
+ Carburetor improperly adjusted+
* Spark plug fouled, broken or incorrect
gap setting_
* Weak or intermittent spark at spark plug.
* Air filter clogged
, Carburetor out of adjusnrmnt+
+ Muffler clogged
+ Clogged exhaust ports.
7+ Engine lacks power
o
+ Spark Arrestor Clogged. +
* Poor compression.
8+ Engine overheats. + Insut_icient oiI in fuel mixture + Mix fueI as described iu slarting
instructions.
+ Air flow obstructed + Clean flywheel cylinder fins and screen.
91 Engine noisy or knocking. + Spark plug in incorrect heat range. + Replace x_ith plugs specified for engine.
* Beatings, piston ring or cylinder walls + Contact your local authorized dealer
are worn.
i0. Engine stalls under load. + Carburetor adjustment mo 'leanY+ + See 'Carburetor AdjustmentY
+ * Remove dust and dirt from between fi_s+
Clean or replace air filter.
See "Carburetor A_ustment"
Clean carbon from muNer+
Remove muff lee rotate engine until the
piston is at top of cylinder. With a
wooden scraper or blunt tool. remove all
carbon from exhaust ports. Be carefu! not
to scratch or damage piston or cylinder
wails+ Blow out all loose ca_on with
compressed air+Install muffler and gasket.
Clean Spark Arrestor
Contact your local authorized dealer.
14

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mantis 7222 and is the answer not in the manual?

Mantis 7222 Specifications

General IconGeneral
BrandMantis
Model7222
CategoryTiller
LanguageEnglish

Related product manuals