Need help?Do you have a question about the Marantz 2250B and is the answer not in the manual?
General| Power Output | 50 watts per channel into 8Ω (stereo) |
|---|---|
| Total Harmonic Distortion | 0.1% |
| Damping Factor | 45 |
| Input Sensitivity | 2.2mV (MM), 180mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Tuning Range | FM |
Align AM IF transformer L153 for maximum height and flat top symmetrical response.
Align AM oscillator coil L152 and ferrite rod antenna/RF coil L151 for maximum audio output.
Adjust R178 for 90% signal strength meter reading at 1000 kHz.
Align FM oscillator coil L104, C106, L101, L102, L103, L105 for max output and min distortion.
Align discriminator transformer L201 for center tuning meter indication.
Adjust R374 for 90% signal strength meter reading at 98 MHz.
Align R311 for 19 kHz reading and R301 for maximum stereo separation.
Align R363 for 0.75V DC and R362 for proper muting circuit frequency shift.
Set RC01, RC02 for 580mV output at TAPE OUTPUT terminals for Dolby FM.
Adjust R806 for 35V DC between pin terminals 804 and 805.
Adjust R707 for 'zero' DC output on speaker terminals.
Adjust R719 for 10mV DC between pin terminals 708 and 710.
Adjust R408, R409 for equal clipping level during 1 kHz signal input.
To Next Page
