o
Auro-3D Mode
Select how to output sound to all speakers when Auro-3D decoding is
active.
Channel Expansion
(Default):
Incoming Auro-3D content is expanded to
additional speakers. All speakers
configured for Auro-3D will output sound.
Direct:
Incoming Auro-3D content is sent directly
to each corresponding channel. No
content is sent to additional speakers.
0
You can set this when the input signal contains Auro-3D signal and sound
mode is set to Auro-3D.
o
Speaker Select
Selects which speakers output sound, depending on the current sound
mode.
Floor:
Plays back without height speakers.
Floor & Height
(Default):
Plays back with height speakers.
0
This can be set when the sound mode is the original sound mode.
o
Subwoofer
Turn subwoofer output on and off.
On
(Default):
The subwoofer is used.
Off: The subwoofer is not used.
0
You can set this when the sound mode is “Direct” or “Stereo” and in the menu
“Subwoofer Output” is set to “LFE + Main”. (v p. 237)
o
Set Defaults
The “Surround Parameter” settings are returned to the default settings.
Contents
Connections Playback Settings Tips Appendix
180
Front panel Display Rear panel Remote Index
To Next Page
Loading...
