Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey
®
Setup.
0
If you enable new speakers in the speaker configuration menu after
performing Audyssey
®
Setup, you will no longer be able to select
Audyssey MultEQ
®
XT32, Audyssey Dynamic EQ
®
or Audyssey
Dynamic Volume
®
. (v p. 183)
0
Changing the following settings:
Speaker size (Large or Small) / Distances / Levels / Crossovers settings
will not disable Audyssey
®
or require running Audyssey
®
Setup again.
0
“Manual Setup” can be used without changing the settings. Please set if
necessary.
Amp Assign
You can change the Preamplifier assignment according to your speaker
system.
o
Assign Mode
Select how to use the Preamplifier.
You need to configure the detailed settings for the speaker
configuration in accordance with the selected mode. Select Assign
Mode configure the corresponding detailed settings.
15.1ch
(Default):
0
All Preamplifiers of this unit are used
for MAIN ZONE.
13.1ch (Bi-Amp):
0
The Preamplifier of this unit is
assigned to 2-channels for creating bi-
amp connections with the front
speaker.
0
You can connect speakers for up to
13.1-channels for MAIN ZONE.
13.1ch + Front B:
0
The Preamplifier of this unit is
assigned to 2-channels for connecting
to the second front speaker.
0
You can connect speakers for up to
13.1-channels for MAIN ZONE.
Custom:
0
Assign the Preamplifier for the 15
channels of this unit however you
want.
To set the channels to be assigned to the
PRE OUT connector, refer to “Settings”.
(v p. 225)
Contents Connections Playback Settings Tips Appendix
215
Front panel Display Rear panel Remote Index
To Next Page
Loading...
