Marantz AV 10 - Page 266

Specifying the zone used with the remote control unit
SETUP
MAIN
Z2
Z3
To prevent accidental misuse, you can set the zone for which the remote
control unit is used.
1
Press and hold down either MAIN, Z2 or Z3 and SETUP
at the same time until the MAIN, Z2 and Z3 indicators
flash green.
MAIN: When only using MAIN ZONE
Z2: When using MAIN ZONE and ZONE2
Z3
(Default):
When using MAIN ZONE, ZONE2 and
ZONE3
Contents Connections Playback Settings Tips Appendix
266
Front panel Display Rear panel Remote Index