Marantz CD-17 - Troubleshooting

USING
THE
REMOTE
CONTROL
UNIT
1. Remote control
Operate
the
remote
control
unit
(RC-63CD)
within
a
distance
of
approx.
5
m
from
the
infrared
signal
reception
window
(remote
sensor)
on
the
front
of
the
CD
player.
,
Remote
control
operation
may
not
be
possible
if
the
remote
control
unit's
transmitter
is
not
pointing
in
the
direction
of
the
remote
sensor
or
if
there
is
an
obstruction
between
the
transmitter
and
the
remote
sensor.
Remote control operating range
CD player
Approx. 5 m
2. Loading batteries
Batteries
in
this
remote
control
unit
have
a
life
of
approximately
1
year
under
normal
operating
conditions.
If
the
remote
control
unit
is
not
going
to
be
used
for
an
extended
period
of
time,
remove
the
batteries.
Also,
if
you
notice
that
the
batteries
are
starting
to
run
down,
replace
them
as
soon
as
possible.
@ Remove the battery cover.
Remote control unit (RC-63CD)
Rear. side
@ Insert the batteries with correct +/- orientation.
Two AA-size (R6) batteries
@Close the battery cover until it clicks shut.
SS
12
TROUBLE - SHOOTING
If you think a malfunction has occurred, first check the points listed below,
The problem is likely to have been caused by a simple operational error or
a connection problem. If the problem cannot be corrected even after
carrying out the following checks, consult your dealer or nearest Marantz
sales office or service counter.
¢ The disc fails to rotate.
1. ls the mains lead plugged in properly?
2. Is the POWER switch ON?
3. Is the disc placed in the correct position on the disc tray?
4. Is the disc placed properly with the label side facing up?
5. Is the disc dirty?
6. Is the disc scratched?
7. \s the disc warped?
8. Have the transport screws been removed?
¢ The disc is rotating but no sound is heard.
1. Are the amplifier and speakers connected properly?
2. Is the amplifier switch ON?
3. Is the amplifier's volume control set at the minimum level?
4. ls the amplifier’s selector switch set to the correct input ("CD” or
"AUX", whichever corresponds to the input jacks the CD player is
connected to)?
* The disc stops in mid-operation.
1. ls the disc dirty?
2. Is the disc scratched?
3. Is the disc warped?
¢ The sound drops out or noise is heard.
1. Is the disc dirty?
2. \s the disc scratched?
3. ls the disc warped?
¢ Remote control operation is not possible.
1. Isthe RC-63CD remote control unit's transmitter pointed correctly atthe
remote sensor on the front of the CD player?
Or is there an obstruction between the transmitter and the remote sensor?
2. Are the batteries in the remote control unit (RC-63CD) exhausted?
3. Is there another strong light (from a window, etc.) striking the CD
player's remote sensor?
4. Isan RCA-type pin-plug lead connected to the "REMOTE CONTROLIN”
jack on the CD player's rear panel?