I want to prevent this unit from going into standby by linking to the power off operation of an HDMI connected TV
0
Change the “HDMI Power Off Control” setting to “Off”. (v p. 102)
Simple operations in the power off state
0
Press the p button to automatically turn the unit’s power supply on and start playback of the last selected input source.
0
When the “Network Control” function is set to “On”, you can perform playback, or other operations through AirPlay or HEOS app. (v p. 107)
I want to connect a power amplifier to this unit
0
A power amplifier can be connected to the analog audio output connectors (VARIABLE) on the rear panel. Set “Variable Out” to “On” in the setup menu.
(v p. 98)
0
Set the remote control operation mode of the volume buttons on the remote control to network CD player operation mode to adjust the volume of the
audio signal output from the analog audio output connectors (VARIABLE) using the remote control. (v p. 109)
0
Set “Line Out Level” to “Variable” in the setup menu to adjust the volume of the audio signal output from the analog audio output connectors
(VARIABLE) using the TV remote control (HDMI control function) and HEOS app. (v p. 98)
I want the volume not to become too loud by mistake
0
Set the volume upper limit for “Volume Limit” in the menu beforehand. This prevents children or others from increasing the volume too much by mistake.
(v p. 99)
Contents
Connections Playback Settings Tips Appendix
113
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
