Marantz CD6005 - Playing Cds ····················································································· 27; A-B Repeat Playback; Playing Tracks in a Specific Order (Program Playback)

29
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
A-B repeat playback
You can specify the section within a track that you want to hear, and play
it back repeatedly.
1
During playback, press REPEAT A-B at the point where
you want to start playing repeatedly.
“Repeat A-“ is displayed on the display.
2
Press REPEAT A-B at the point where you want to stop
playing repeatedly.
“Repeat A-B” is displayed on the display, and the specified section
(point A to point B) is played back repeatedly.
2 To cancel A-B repeat playback
Press REPEAT A-B.
NOTE
• A-B repeat playback cannot be used during random playback.
Playing tracks in a specific order
(Program playback)
Up to 25 tracks can be programmed.
1
In the stop mode, press PROG.
“Program” is displayed on the display.
2
Use 0 – 9 to select the tracks you want to program.
GExampleH
To program tracks 3 and 12 to be played in that order, press 3, 1,
and 2 one after the other.
• The entered numbers are set approximately 1.5 seconds after the
number buttons are pressed. To enter a two-digit number, be sure
to press the two number buttons, one immediately after the other.
3
Press 1.
Playback starts in the programmed order.
%
• You can specify up to 25 tracks each for program playback.
• When RANDOM
is pressed during program playback, the programmed tracks
are played in random order.
• When REPEAT
is pressed during program playback, the tracks are played
repeatedly in the programmed order.
NOTE
• The program is cleared when the disc tray is opened or the power is turned o.