Marantz CD6005 - Schematic Diagrams (4;4); Main CD DSP USB Schematics

50
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
2 Operations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be performed
through the remote control unit.
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an
angle of within 30°.
• Remove any obstacle between this unit and the remote control unit.
• Insert the batteries in the proper direction, checking the q and w marks.
• The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type
fluorescent bulb light, etc.). Move the set to a place in which the remote control sensor will
not be exposed to strong light.
• When using a 3D video device, the remote control unit of this unit may not function due to
eects of infrared communications between units (such as TV and glasses for 3D viewing). In
this case, adjust the direction of units with the 3D communications function and their distance
to ensure they do not aect operations from the remote control unit of this unit.
• Press the REMOTE MODE CD button to switch the remote control operating mode to “CD”.
5
5
–
5
–
–
11
2 Display on this unit shows nothing
Symptom Cause / Solution Page
Display is o. • Press DIMMER, and change the setting to anything other than o.
• The display is switched o when the sound mode is set to “Audio EX 2”.
26
26