Marantz M1 - Adding Wired HEOS Devices

Adding the registration of HEOS built-in devices in the HEOS app
The HEOS system is a true multiroom audio system that automatically synchronizes audio playback between multiple HEOS built-in devices so that the
audio coming from different rooms is perfectly in sync and always sounds amazing! You can easily add up to 32 HEOS built-in devices to your HEOS
system.
Adding wired HEOS built-in devices
Just connect the HEOS built-in devices to your home network using an Ethernet cable and the HEOS built-in device will appear on your HEOS app as a
new room in the Rooms screen.
At your convenience, you can assign a name to the HEOS built-in device to indicate which room you have it placed in.
0
Use only a shielded STP or ScTP LAN cable which is easily available at electronics stores (CAT-5 or greater recommended).
0
The normal shielded-type LAN cable is recommended. If a flat-type cable or unshielded-type cable is used, other devices could be affected by noise.
0
Do not connect a NETWORK connector directly to the LAN port/Ethernet connector on your computer.
Contents
Setup Playback Troubleshooting Status LED Appendix
13