o
Deep Standby
This unit also has the ability to automatically enter Deep Standby
Mode whenever the wired or wireless network connection is removed
for more than 60 minutes in Quick Start Mode. The front panel LED will
turn off during Deep Standby.
To wake this unit from Deep Standby,
0
Press any button on this unit.
0
Input audio signal to optical input.
0
CEC (Consumer Electronics Control) command over HDMI
eARC/ARC
0
Use a TV remote control that has learned the operations of this unit
with the remote control learning function to operate this unit.
(v p. 29)
0
You also press the 13 key for 5 seconds, the device enters the Deep
Standby.
NOTE
0
If “Power Saving” is set to “Quick Start” in the HEOS app, the unit will not
switch to Deep Standby Mode. (“Settings” - “My Devices” - (“Device Name”) -
“Power Saving”)
o
Off
To completely turn off the power to the device you must remove the
mains plug from the power outlet.
Contents
Setup Playback Troubleshooting Status LED Appendix
43
To Next Page
Loading...
