Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
.
X
ZONE2 SOURCE INTERNET RADIO
M-DAX
DIMMER STATUS
Disabling the sensor function of the
remote control unit
1
Press X while you press and hold M-DAX and DIMMER
with the unit in standby mode.
2
Use ZONE2 SOURCE or INTERNET RADIO to select “RC
LOCK On”.
3
Press STATUS to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
Press X while you press and hold M-DAX and DIMMER
with the unit in standby mode.
2
Press ZONE2 SOURCE or INTERNET RADIO to select
“RC LOCK zOff”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
Infrared light receiving function on the main unit is enabled.
Contents Connections Playback Settings Tips Appendix
134
Front panel Display Rear panel Remote Index
To Next Page
Loading...
