Marantz PM-11S1 User Manual

20
ENGLISH
ENGLISH
77
77
7 How to Trim Bass
The bass level of the left and right channels can be trimmed in
2 dB steps across a -8.0 - +8.0 dB range. When the PM-11S1
is shipped from the factory, the bass level is set to 0 dB. To trim
the bass level, activate tone control by pressing the TONE
button on either the PM-11S1 or the remote controller.
1. Press the TRIM button once to access the LEVEL trimming
mode.
2. Press the ENTER button once to access the BASS
trimming mode.
3. The flashing “0” on the left indicates that trimming is
activated for the left channel bass level. Press the 3 and 4
buttons to set the bass level of the left channel.
4. Press the 2 button to start the “0” on the right side flashing.
When the right side “0” starts flashing, trimming is activated
for the right channel bass level. Press the 3 and 4 buttons
to set the bass level of the right channel.
5. To trim the bass level of the ID 2 (slave) PM-11S1, press
the TRIM button again and set bass level as in steps 1 - 3.
After that, pressing the TRIM button again allows you to
trim bass level with ID 3 (slave) PM-11S1 and so forth.
6. When finished with bass level trimming, press the EXIT
button.
HOW TO USE AND SET FEATURES
77
77
7 How to Trim Treble
The treble level of the left and right channels can be trimmed
in 2 dB steps across a -8.0 - +8.0 dB range. When the PM-
11S1 is shipped from the factory, the treble level is set to 0 dB.
To trim the treble level, activate tone control by pressing the
TONE button on either the PM-11S1 or the remote controller.
1. Press the TRIM button once to access the LEVEL trimming
mode.
2. Press the ENTER button twice to access the TREBLE
trimming mode.
3. The flashing “0” on the left indicates that trimming is
activated for the left channel treble level. Press the 3 and
4 buttons to set the treble level of the left channel.
4. Press the 2 button to start the “0” on the right side flashing.
When the right side “0” starts flashing, trimming is activated
for the right channel treble level. Press the 3 and 4 buttons
to set the treble level of the right channel.
5. To trim the treble level of the ID 2 (slave) PM-11S1, press
the TRIM button again and set treble level as in steps 1 - 3.
After that, pressing the TRIM button again allows you to
trim treble level with ID 3 (slave) PM-11S1 and so forth.
6. When finished with treble level trimming, press the EXIT
button.
PM-11S1NENG(P09-P26)A4 04.8.17, 11:37 PMPage 20 AdobePageMaker6.5J/PPC

Marantz PM-11S1 Specifications

General

Brand	Marantz
Model	PM-11S1
Category	Amplifier
Language	English