How to fix a Marantz Amplifier remote control that is not working?
If your Marantz Amplifier's remote control isn't working, try these steps: Replace the batteries with new ones, ensuring they are inserted in the correct direction, checking the q and w marks. Operate the remote within 7 meters and at an angle within 30°. Finally, press the REMOTE MODE AMP button to set the remote control operating mode to 'AMP'.
What to do if my Marantz PM10S1GD turns off and the standby indicator flashes red?
If your Marantz Amplifier power turns off and the STANDBY indicator flashes red approximately every 0.5 seconds, the protection circuit has been activated due to a rise in temperature within the unit. Turn the power off, wait about an hour for it to cool down, and then turn it on again.
How to stop my Marantz PM10S1GD Amplifier from automatically turning off?
To stop the power from automatically turning off on your Marantz Amplifier, disable Auto Standby mode by setting 'AUTO STBY' in the menu to 'OFF'.
Why does no sound come out of the speakers on my Marantz PM10S1GD?
If no sound is coming from the speakers connected to your Marantz Amplifier, verify the connections for all devices. Ensure speaker cables are properly connected, with cable core wires contacting the metal part on speaker terminals, and that terminals are securely tightened. Select the correct input source, adjust the volume, and cancel any muting mode. Note that no sound will be output from the speakers when headphones are connected.
Why is the stereo sound reversed on my Marantz Amplifier?
To resolve the issue of the left and right stereo sound being reversed on your Marantz Amplifier, check whether the left and right speakers are connected to the correct speaker terminals.
Why is there a humming noise when playing a record on my Marantz PM10S1GD?
To address a humming noise coming from the speakers when playing a record on your Marantz Amplifier, ensure the turntable is connected correctly. If there is a TV or AV device near the turntable, these devices may be affecting the playback sound. Position the turntable as far away as possible from TVs or other AV devices.
Why does no sound come out of a specific speaker on my Marantz Amplifier?
If no sound is coming out of a specific speaker connected to your Marantz Amplifier, make sure the speaker cables are properly connected. Also, adjust the left and right channel balance.
Why is the sound distorted when playing a record on my Marantz PM10S1GD?
If the sound is distorted when playing a record on your Marantz Amplifier, adjust to a proper needle pressure. If the distortion persists, consider replacing the cartridge.
How to stop the humming noise when playing records loudly on my Marantz PM10S1GD Amplifier?
To prevent a humming noise (howling phenomenon) when playing a record at high volume on your Marantz Amplifier, install the turntable and speakers as far from each other as possible.
General| Power Output (8 ohms) | 200 W |
|---|---|
| Power Output (4 ohms) | 400 W |
| Frequency Response | 5 Hz - 50 kHz |
| Total Harmonic Distortion (THD) | 0.005 % |
| Input Impedance | 47 kΩ |
| Input Sensitivity (MM) | 2.5 mV |
| Input Sensitivity (MC) | 0.3 mV |
| Input Sensitivity (High level) | 200 mV |
To Next Page
