2
ENGLISH
BEFORE USE
This section must be read before any connection is
made to the mains supply.
7
Equipment mains working
setting
Your Marantz product has been prepared to comply
with the household power and safety requirements
that exist in your area.
PM5003 can be powered by 230V AC only.
7
Copyright
Recording and playback of any material may
require consent. For further information refer to the
following:
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— Any subsequent statutory enactments and
orders
7
Do not locate in the following
places
To ensure long-lasting use, do not locate the
PM5003 where:
• Exposed to direct sunlight.
• Near to sources of heat such as heaters.
• Highly humid or poorly ventilated.
• Dusty.
• Subjected to mechanical vibrations.
• On wobbly, inclined or otherwise unstable
surfaces
• Radiated heat is blocked such as in cramped
audio racks.
To ensure proper heat radiation, ensure the below
clearance from walls and other equipment.
Left
0.2 m or more
Above
0.2 m or more
Right
0.2 m or more
Rear
0.2 m or more
7
Keep objects off
Keep objects off the PM5003. Blocking the vent can
result in accident and damage.
7
Do not touch hot spots during
and Immediately after use
During and immediately after use, the PM5003
is hot in areas other than the controls and rear
panel connection jacks. Do not touch hot spots and
especially the top panel. Contact with hot areas can
cause burns.
FEATURES
• Current feedback amplifier for both pre-amplifier and power amplifier
• Wide range, high speed playback for super audio sources
• Improved and optimized the circuit design, parts and pattern wiring
• Input buffer circuit for high S/N ratio and high channel separation
• Active filter type tone control circuit
• Source direct function for purity audio playback
• Phone equalizer amplifier (for MM contridge)
• System remote control
To Next Page
