Why can't I change surround mode on my Marantz Receiver?
If you cannot change the surround mode, check if headphones are connected to the jack. When headphones are connected, the surround mode is fixed to STEREO. Disconnect the headphones to change the surround mode.
What causes noise during DTS-encoded CD or laser disc play on Marantz Receiver?
If you're getting noise during DTS-encoded CD or laser disc playback, ensure you're using a digital connection and have selected digital input. The issue may arise if analog input is selected instead.
How to resolve noise during FM reception on Marantz Receiver?
If you're hearing noise during FM reception, the radio waves from the broadcasting station might be weak. Consider installing an FM outdoor antenna to improve reception.
What to do if my Marantz SR4200 has no output to Sub Woofer Out?
If there's no output to the Sub Woofer Out, check the SETUP mode. If 'Sub-woofer = NO' is selected, change it to 'Sub-woofer = YES'.
Why can't DTS sources be played on my Marantz SR4200 Receiver?
If DTS sources cannot be played, it might be because the Surround mode is set to DOLBY. Select another mode. Also, ensure that your DVD or LD player is DTS digital out capable.
General| Channels | 6.1 |
|---|---|
| Dolby Decoding | Dolby Digital, Dolby Pro Logic II |
| Video Outputs | 1 composite, 1 S-video |
| Total Harmonic Distortion | 0.08% |
| Signal to Noise Ratio | 98 dB |
| DTS Decoding | DTS, DTS Neo:6 |
| Inputs | 2 digital optical, 2 digital coaxial |
| Outputs | 1 digital audio (optical) |
| Dimensions | 440 x 158 x 416 mm (W x H x D) |
| Tuning Range | FM |
| Frequency Response | 10Hz-100kHz (+1/-3 dB) |
| Input Sensitivity | 200mV |
| Video Inputs | 4 composite, 2 S-video |
| Weight | 21.6 lbs (9.8 kg) |
To Next Page
