Marantz TT-6000 - Table of Contents

INTRODUCTION
This service manual was prepared for use by Authorized
Warranty Stations and contains service information for
a Marantz Semi-Automatic Quartz Lock TT-6000 Turn-
table. Service information and voltage data included in this
manual are intended to be used by experienced service
technicians, knowledgeable in Turntable designs and Ser-
vice. All instructions should be read and no attempt to
repair the circuits or mechanisms should be made until
complete operation is understood.
The parts list in this manual pertains to five different
areas. Be sure that part numbers for your respective area
are correct before parts orders are placed. A simple des-
cription is provided for parts which can be purchased
locally or through the Marantz Parts Facilities. Refer to
the Marantz Design and Service Section of this manual for
correct parts ordering methods.
TT-6000 SERVICE MANUAL CONTENTS
SUBJECT
MARANTZ DESIGN AND SERVICE .
CARTRIDGE WIRE COLOR CODE
STYLUS OVERHANG ADJUSTMENT
STYLUS TRACKING FORCE ADJUSTMENT
TONE ARM TRAVEL ADJUSTMENT
PHOTO CELL DETECTION CIRCUIT
LEAD IN ADJUSTMENT
ELEVATION PLATE ADJUSTMENT .
ELECTRONIC ADJUSTMENT .
PHASE LOCK ADJUSTMENT
WOW AND FLUTTER ADJUSTMENT
CIRCUIT WAVEFORM ANALYSIS
TT6000 TROUBLE SHOOTING CHART
TT6000 FINAL ASSEMBLY .
TT6000 WIRING DIAGRAM
POWER SUPPLY CIRCUIT BOARD
MOTOR CONTROL CIRCUIT BOARD
SWITCH CIRCUIT BOARD .
SWITCH LOGIC CIRCUIT BOARD
CIRCUIT VOLTAGE CHARTS .
TT6000 ELECTRICAL SCHEMATIC .
TT6000 SWITCH LOGIC CIRCUIT SCHEMATIC .
SWITCH CIRCUIT DESCRIPTION .
AUTOMATIC RETURN CIRCUIT DESCRIPTION
TT6000 MECHANICAL ASSEMBLY .
PARTS LIST .
TT6000 TECHNICAL SPECIFICATIONS
PACKAGING ASSEMBLY
PAGE
Oo OnNnNN OD DN FP FF WW WWNY YN HY NYDN ND =
a ee)
= © ©
12-13
14
14