WARNING DECAL REQUIREMENTS
When your baler leaves the factory, several WARNING DECALS are installed for pro-
tection. These labels are subject to wear and abuse due to the nature of the operation.
THESE DECALS MUST BE MAINTAINED. Additional decals may be purchased
through your distributor.
1 OPERATION
DECALS
CAUTION: DO NOT OPERATE BALER UNTIL OPERATING
INSTRUCTIONS ARE UNDERSTOOD. NEVER PLACE ANY
PART OF BODY INSIDE BALE CHAMBER. STAND CLEAR
WHILE BALER IS IN OPERATION. FEDERAL LAW PRO-
HIBITS OPERATION OF THIS EQUIPMENT BY PERSONS
UNDER 18 YEARS OF AGE. TURN OFF AND REMOVE KEY
AFTER USE. STAND CLEAR WHILE EJECTING BALE.
(Also, includes Operating Instructions).
WARNING: STAY CLEAR OF BALE CHAMBER WHEN
LIGHT IS ILLUMINATED. IF LIGHT IS ILLUMINATED WHEN
BALE DOOR OR FEED GATE IS OPEN, DISCONTINUE
USE OF THIS EQUIPMENT AND CALL QUALIFIED SER-
VICE PERSONNEL.
DANGER: STAY OFF TOP BALER. DO NOT CLIMB ON
SIDES. USE WORK PLATFORM FOR SERVICING.
NOTICE BALE MADE IF ARROW DOES NOT PASS.
(V-4830 & V-6030 ONLY)
ORANGE ARROW.
(V-4830 & V-6030 ONLY)
Decal Number 06-0130 -
Decal Number 06-0132 -
Decal Number 06-0133 -
Decal Number 06-0651-
Decal Number 06-0652 -
1-19
To Next Page
Loading...