I.
ACCESSORIES
"IREPLACE GRATE:
ise of the grate is required. It has been desigtred to keep the
operatiorr of your fireplace efficierrt and safe.
GLASS DOORS:
Bifold glass doors can be installed as an optional accessory. Use
Marco door kit
#793412
and refer to the installation instructions
within that
kit. The glass doors car1 be installed before, during or
after installation of
the
fireplace.
NOTE:
Use of glass doors
other than those manufactured by
4farco
?If&,
Inc.
could create
a
potentially hazardous condition an11 will
void the hlarco warranty.
FAN
KITS
(Heat Circulating Models only):
A
fan kit (Mnrco part
#793623)
is available for use with hcaf
circulating models as an optional accessory. The fan kit can
he
installed prior to, or after installation of the fireplace.
NOTE:
This
model fireplacedoes not requires wall switch in order for the fans
to operate. Refer to the installation
instriictions within the kit for
instnllation details.
IN
ORDER FOR THE OPTIOSAL
FANS TO OPERATE, THE FIREPLACE
MUST
HAVE
BEEN WIRED TO THE HOUSE ELECTRICAL
SYS-
TEAM AT THE TIME OF INSTALLATION. (See
Fig-
ures
1
and
1A)
NOTE: The utilization of fans will increase the
air flow around the firebox. However, only a
mirrirnal increase
'I
heat output should be anticipated.
POWER
TOTHE
FIREPLACE
The
X793623
Fan
Kit
operates
on
115
volt
60
Hz
Hovls
wiring
mvrl
be
secured
with
the a~~ro~rletc electrical
conneclo~
io
the ilrcplscc
convenience
ovflst
wiring.
eieclrical
hook-up.
1
Fieure
1
I
as
a
substitute for
a
furnace
to
heat an
entire
home.
Use
for supplementary
heatine onlv.
11. INSTALLATION
INSTRUCTIONS
I?;TRODUCTIOK
Before beginning tire installation of your fireplace, read througlr
these instructions and the instructions contained it1 the separate
Operation
Maoual.
This Marco fireplace and its components are safe when installed
according to this installation
manoal. Unless you use hlarco
components which have been designed and tested for this
fireplace system,
you rnay cause a fire hazord.
Marco's Builder 41" fireplaces may be installed in
n
convrntional
or prefabricatrd hunie
The Marco warranty will be voided by, and Marco disclaims any
responsibility for the following actions:
I) blodificationsofthe firepiaceand/or
its
conrponents, includ-
ingthcassernbiy ofchimney, glassdoors, airinletsystnmand
damper control
2)
The use of any component part not manilfactured or ap-
proved by Marco
in
combination witti a Marc0
fireplace
system.
3)
Ir~stallalion other tliaii as instructed in this manual
4)
The use of
a
fireplace insert or other products not specified
for
use
with this fireplace.
PROPER INSTALLATION is
the riiost important step in ensitr-
ing safe, long-term operation of this fireplace. Consult the local
building codes as to the
pxticular reqt~irerncrrts concerliing tlie
installation of all factory-built fireplaces. Alttlouph grounding
may not be required by code, it
is
recomnlfndrd
by
the manufac-
turer.
f i r e - p a r t s . c o m
To Next Page
Loading...
