Marcy Fitness www.marcyfitness.co.uk
STEP 5 (See Diagram 5)
A.) Insert the pivot on the Right Butterfly (#13) into the hole on the Butterfly Base from bottom.
Secure it with one Lock Ring (#35), one Ø ¾” Washer (#107), and one M10 x 5/8” Allen Bolt
(#87). Push the Butterfly Arm Foam Roll (#64) to Right Butterfly. Repeat same step to install
the Left Butterfly (#12).
B.) Insert two Swivel Pulley Brackets (#15) into the holes on the Butterfly Pulley Bracket (#14).
Secure each Swivel Pulley Bracket with one M12 x 5” Hex Bolt (#100), two Ø 1” Washer
(#108), and one M12 Aircraft Nut (#111). Do not over tighten the Nuts. Make sure the
Brackets are able to swivel.
To Next Page
Loading...
