Fuel tank empty.
Engine oil level too low.
Emergency stop engaged.
Broken spark plug.
PTO engaged during start.
Refuel.
Add engine oil.
Disengage Emergency stop.
Replace spark plug.
Dis-engage PTO.
Fuel tank nearly empty.
Wrong fuel in fuel tank. (see 2.0
for correct fuel)
Choke still engaged.
Clogged air filter.
Contaminated fuel system.
Stop and refuel.
Stop, drain fuel, and refuel.
Disengage choke.
Clean or replace air filter.
Drain and clean fuel system.
PTO lever not in the correct
position.
V-belts need to be re-tightened.
Put the PTO lever in the correct
position.
Re-tighten or replace V-belts.
STrac 700
does not drive
or lift the
hitch.
Broken chain drive.
Hydraulic oil leak.
Hydraulic oil level too low.
Replace chain and sprockets.
Stop, check for leaks, and repair
the leak.
Stop and fill hydraulic tank to the
correct level.
STrac 700 is
hanging to
one side.
STrac 700
does not move
forwards or
backwards
Handbrake still engaged.
Wheel stuck.
Hydraulic oil level too low.
Dis-engage handbrake.
Check if front wheel can rotate free
and remove obstacle(s).
Check hydraulic oil level.
Loose components.
Clogged ST head.
Check and repair loose parts.
Clean ST head and reduce working
depth of ST head.
Engine is
stuck and
does not
rotate
PTO clutch still engaged.
Square
(rear)wheel
locking pin
does not fit
correct in the
holes.
Wheel bracket stop bolts not
adjusted correct.
Wheel turned while ST head is
not in float position.
Brackets not aligned.
Adjust the stop bolts.
Lower ST head and try again.
Push gently against the bottom of
the rear wheel or pull on the
bottom of the side leg to align the
holes.
Round pin for
locking rear
‘door’ bracket
does not fit
Push or pull the rear ‘door’ bracket
gently left and right until the holes
align. Or lift the rear wheel a little
to let holes align.
STrac 700 is
unstable in
undulated
areas
Wheels are in the rear position
Position wheels beside the machine
To Next Page
Loading...