14.0 Options manual: ST418 VibeDisc-Seeder
The MAREDO ST418 VibeDisc-Seeder is a
disc overseeder. Vibratory discs pre-cut
slits. Smaller discs placed in a V-shape
open the slit and allow seed to drop into
the slit.
14.1 First start: After connecting
the ST418 to the STrac 700 (See
5.2 ST head connection Working
depth can be adjusted by turning
the top link on top of the ST418
head. Extending the top link will
decrease the working depth. Shortening the top link will increase working depth.
Make sure to lock the top link with the locking nut after adjusting.
After the depth adjustment seed dosing rate can
be set. This can be done by changing gear
reductions in the gearbox beside the rear
roller. The highlighted green gears in the
image on the right can be interchanged for
other gear reductions. A dosage decal on
the inside of the gearbox shows which
dosage amount comes with which gear
reduction. The extra gears are standard
supplied.
14.2 Lock ST head: See 11.2 Lock ST head
14.3 Check V-belt drive: See 13.3 Check V-belt drive.
14.4 Maintenance: Clean and check for broken or loose parts. Only use original
MAREDO spare parts. Always clean with low pressure water or compressed air.
Never use a high-pressure washer. Always remove seed from seed box after each
use. Clean funnels with compressed air blowing through the funnels.
To Next Page
Loading...