Mares Nemo WIDE - EAN Dive Mode Data; EAN No-Decompression Dive Data; EAN Decompression Stop Dive Data

42
DIVE  EAN:
“NODECOMPRESSION” DIVE
When the diver descends below 1.2 meters (4 ft)
Nemo Wide automatically switches to Dive Mode
and starts displaying the dive data.
If this mode persists for more than 20 seconds,
Nemo Wide will begin recording the dive details in
the Log Book memory.
The following details are displayed (Fig. 23):
• current depth (in “m” or “ft”);
• no decompression time remaining, expressed in
minutes;
• “no deco” icon;
• icons for the altitude program and personal
correction factor (if enabled).
• the % O
2
;
• the % CNS.
FIG. 23
NOTE
The procedure for scrolling the items on
the display is identical to that described in
the section on diving with compressed air.
NOTE
The functions of the buttons are identical
to those described in the section on
diving with compressed air.
In this mode the buttons function as follows:
<+> button:
• Press this button to display the maximum depth
reached. Press it again to remove the maximum
depth.
• Hold down the button for 2 seconds to activate
the display backlight.
<-> button:
by pressing this button you can choose to view on
the display bar:
• the % O
2
;
• the % CNS.
Or
• the temperature (in °C or in °F);
• the duration of the dive so far (dive time) in digits.
<ENTER> button:
• hold down this button to display the dive
settings with the same window as the Predive
mode.
<ESC> button:
• When the <ESC> button is pressed during
the dive, Nemo Wide will temporarily display
the estimated deep stop required. The data
displayed during the ascent may vary as a result
of the diver’s behavior. Divers should check
this data during the ascent for more precise
information on the estimated stop.
DIVE  EAN “DECOMPRESSION
STOP” DIVE
The data displayed for decompression-stop diving
with EAN are as follows (Fig. 24):
• “deco” icon;
• current depth (in “m” or “ft”);
• depth of deepest decompression stop
(in “m” or “ft”);
• duration of the deepest decompression stop;
• icons for the altitude program and personal
correction factor (if enabled).
FIG. 24
In this mode the buttons function as follows:
<+> button:
2334-Nemo Wide-ing-rev.indd 422334-Nemo Wide-ing-rev.indd 42 19/09/2006 11.09.5119/09/2006 11.09.51
JoeDiverAmerica.com