EN
Dive - Bottom Time (gauge)
In this mode Nemo functions as an electronic timer and
depth gauge, but does not perform any calculations for
no-deco limits or for deco-stop times. Responsibility for
planning the no-decompression limits or an adequate
decompression, therefore, lies entirely with the user. The
details displayed in Predive and Surfacing mode are the
same as those already described for air or Nitrox dives.
The details displayed in Dive Mode are instead the
following:
• current depth;
• duration of the dive in minutes (also analog) and seconds;
• ascent rate;
• temperature (in °C or in °F);
• the primary time.
Pressing the <+> or <-> buttons displays, for
approximately 8 seconds, the maximum depth reached
so far.
42
WARNING
It is recommended to always to
begin the dive with Nemo set to
Predive mode.
This ensures correct functioning even
if the wet contacts are dirty with salt,
oil, sunscreen etc...
In any case, as you begin your dive
always check that the computer has
effectively activated.
To Next Page
Loading...
