EN
43
Surface mode - BT
The desaturation time and the delay before flying or
traveling to high altitudes are displayed in the same
way as for Air or Nitrox dives.
Bottom Time with behavior error
The following errors can occur during an air or Nitrox
dive:
• uncontrolled ascent;
• omitted stop.
In this case, Nemo will inhibit the Dive - Air and Dive -
EAN modes for 24 hours, allowing only operation in BT
mode, while continually displaying the underwater
behavior error in question.
The corresponding error icons are displayed in Dive,
Surface and Logbook mode.
Note:
Note: After a dive in "BT" mode, the transition to "Air" or "Nitrox"
mode will be disabled for 24 hours. (This lockout can be disabled by
clearing the residual nitrogen memory in Set Dive - Data mode).
WARNING
This option is intended only for highly
experienced divers. Users who clear
the residual nitrogen memory cannot
then use the instrument for repetitive
dives. After this operation, do not
dive with Nemo if you have already
dived within the previous 24 hours.
To Next Page
Loading...
